Subtotal: $0.00 Cart
  • the source of our inspiration

    premium, archival fine art inkjet papers wrapped in the intimacy of a rural culture

  • juniper baryta rag

    our best reviewed and most award-winning paper yet


    Photo: Andy Biggs

    "All my portfolios are printed on Entrada. It's necessary that each print stands alone as a piece of art, and it's because of Entrada's weight and feel that my portfolio stands out from the rest."


Moab Support Forum > Post-printing curl on Juniper

I am liking the color rendition and tooth of Juniper Baryta Rag very much. But I am having one problem. Printing 13x19 on an Epson 3880 it lies flat out of out of the box and in the printer, but after it is printed, the paper bellies up, about 1 inch in the middle. It goes down a bit after drying completely, but never goes away. Is there anything I can do about this?

April 30, 2017 | Unregistered Commentermkatz

Does this occur with all the prints you make on Juniper, or does it vary with the ink load in the image?
And are you using our older profile with the media type of Exhibition Fiber, or the current profile which uses Premium Luster as the media type?

April 30, 2017 | Unregistered CommenterMoab Paper Support

Thanks for getting back. I was using the older EEF profile but switch to the newer UPPPL profile. The bulging is still there, but not as pronounced.

May 2, 2017 | Unregistered Commentermkatz

Also, it does seem to vary with the ink load. The heavier the load, the more it bulges.

May 2, 2017 | Unregistered Commentermkatz